- Materials
-
- 1.6 ml of whole blood
- Consumables
-
- RBC Lysis Solution (QIAGEN, 158106)
- Phosphate-buffered saline (PBS), pH 7.4 (Thermo Fisher, 10010023)
- 15 ml Falcon tubes
- 1.5 ml Eppendorf DNA LoBind tubes
- Equipment
-
- Microfuge
- P1000 pipette and tips
- P200 pipette and tips
- P20 pipette and tips
-
White blood cell sample preparation for the Ultra-long DNA experiment
Approximately 6 million isolated white blood cells must be prepared from 1.6 ml of whole blood to use as input in the Ultra-long DNA experiment.
Users may isolate white blood cells by any means they feel are most appropriate for the whole blood sample to be used. If 6 million cells have been isolated, users can start from the uHMW gDNA extraction step.
-
Add 4.8 ml of RBC Lysis Solution to 1.6 ml of whole blood in a 15 ml Falcon tube.
-
Gently invert the tube ten times to mix.
-
Incubate for 5 minutes at room temperature and gently invert twice during the incubation.
-
Centrifuge at 2000 x g for 2 minutes at 4°C to pellet the white blood cells.
-
Discard the supernatant by pouring. There will be ~200 µl supernatant remaining in the tube.
-
Resuspend the cells in the residual supernatant by gently flicking the tube.
-
Make up the volume to 1.6 ml with 1x PBS.
-
Repeat steps 1-7 twice more to complete three washes in total.
-
After the final spin, remove the entire supernatant by pouring and aspirating any remaining supernatant.
-
Resuspend the cell pellet in 40 µl 1x PBS. There will be approximately 6 million cells in the suspension.