-
The PromethION must be configured for UEFI Hard disk boot before you begin the rebuild process.
-
Power down the Data Acquisition Unit if it is switched on.
-
Insert the bootable USB into the USB port with the blue interior on the back of the device.
Note: If using an A-series/A100 Data Acquisition Unit, you may need to remove one of the USB firmware update cables connected to the sequencer.
-
Power on the Data Acquisition Unit, then when the below screen appears, press Delete to enter setup.
On A100/A-series Data Acquisition Units, ensure you are using the VGA output.
-
Once in setup, press the Right cursor key until Boot is highlighted.
-
Within Boot, configure the following settings:
- Boot mode select: UEFI
- Boot Option #1: UEFI Hard Disk
- Boot option #2: UEFI USB Hard Disk